Powermatic 701 Manual do Utilizador descarregar pdf (Página 13)

13

Chisel Parallel to Workpiece

Referring to Figure 12:

The chisel can be adjusted parallel to the

workpiece as follows:

1. Loosen the two clamps (A) that secure the

fence (B).

2. With the adjust knob (C), move the fence back

far enough to insert the workpiece (D) between

the chisel (F) and fence (B). Raise the

workpiece hold-down clamp (E) if necessary.

3. With the operating handle (G) bring the head

down until the chisel points are almost at the

table level.

4. Bring the fence (B) forward with the adjust

knob (C) until the front edge of the

workpiece (D) rests against the back surface of

the chisel (F), but do not force.

5. Loosen the chisel lock handle (H). This will

allow the chisel to rotate.

Further adjust the chisel by hand if needed.

6. Tighten the lock handle (H) while making sure

the bushing maintains contact with the head

casting to preserve the clearance setting..

Figure 12

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários