Powermatic WP2510 Manual do Utilizador descarregar pdf (Página 34)

Display

Possible cause:

a. no sensor

b. 9-pin connector is loose

c. wire broken

d. the gap between sensor and tape is too large

Excluding: Check the sensor, sensor cable and sensor connector.

Display

Possible cause: Incorrect operation.

Excluding: Press to clear.

Display

This message appears after power-on and indicates battery discharged. The C-type

battery MUST be replaced to resume the operation of the device. Change as follows:

1. Open the planer’s top right side panel to access the rear of the Controller.

Turn the power off. Be careful not to move the table during power off. Replace the

battery and turn the power on. The device will resume normal operation.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Sem comentários

Powermatic WP2510 Manual do Utilizador Página 34